FIT is Fox Isolated Technology= a sealed damper cartridge where the air and oil don’t mix. The FIT cartridges have everything contained inside them. Some benefits of FIT are slightly lighter weight and more consistent feel throughout most riding conditions.

Are 32mm stanchions enough?

32mm stanchions are solid, but once you get to 36, or maybe 34 if you run a tapered steerer or bigger is as solid as you would need unless you weight 100+ and ride downhill.

What is a Fox Fit 4 damper?

FIT4 is the damper of choice for riders looking for a lightweight fork with lockout and loads of performance. The roller bearing kit (right) can be installed without special tools, but Fox says you’ll need their tool kit (left) to remove it correctly.

What is Fox FIT damper?

The FIT Grip damper is a 2 way adjustable damper that you will find on Fox’s Performance series 34 forks. We have been getting a lot of positive feedback on the FIT Grip damper from our customers, and so we thought it would be great to put this damper to the test.

How do I adjust the travel on my 32 mm Talas Forks?

Too soft and you may have excessive brake dive and a wallowy feel. 32 mm TALAS forks feature three externally adjustable travel choices per maximum fork travel specification. These travel settings are easily selected using the TALAS travel adjusting topcap on top of the left fork leg, as shown below.

What do you need to know about the Talas Fork?

TALAS travel adjust system, low-speed compression, lockout, lockout force adjust, air spring pressure, rebound Be sure your fork is properly installed before proceeding. Clicking on the link above will take you to a new page. Check that quick-release levers are properly adjusted and tightened.

How do I adjust sag on my Talas Fork?

To get the best performance from your fork, it is necessary to set and adjust sag. Generally, sag should be set to 15 25% of total fork travel. Unscrew the center blue aircap in the middle of the TALAS travel adjusting topcap on top of the left fork leg (shown below), to expose the Schrader valve.

How do I remove the AirCap from my Talas Fork?

This will facilitate removal of the aircap and also protect the TALAS lever from being forced past its stops. Attach a FOX Racing Shox High Pressure Pump to the Schrader valve. Using the Air Spring Settings table below, pump your fork to the appropriate setting using the FOX High Pressure Pump, then remove the pump.