Reballing your PS3( re-soldering the chip joints ) Look for a reballing service. Ideally, the service will use more durable leaded solder instead of Sony’s lead-free solder. It’s likely to last many years. So you’re looking at the initial reballing cost (roughly 125$USD) + likely future repairs.

What temperature should I reflow my PS3?

Reflow the CPU and GPU. You want your heat gun to get to roughly 300º C and wave it around 3–4 inches (7.6–10.2 cm) off the surface of each component. You are looking to melt the solder inside these components so the point is to get them really hot.

What does Reball mean?

Reballing involves dismantling, heating the chip until it can be removed from the board, typically with a hot-air gun and vacuum pickup tool, removing the device, removing solder remaining on the device and board, putting new solder balls in place, replacing the original device if there was a poor connection, or using …

How long does a reflow last?

some people have reported weeks or months, but in general it’s hardly a permanent fix. Typically reflows last longer on the older 7×00 GPUs, but even then it’s hardly permanent.

What is the difference between reflow and reball repair?

Reball Method Repair – A reball repair is the same procedure as the reflow, but with a few more steps involved. Instead of just heating the chip and letting the solder underneath melt, the chip is heated to the point where it can be taken off the board.

Where can I read reviews of the PS3 GPU reballing service?

Click here to read our customers reviews AND WATCH OUR PICTURES to know that you are at the right place if you are looking for the real and the top quality Reballing process for your PlayStation 3.

How much does it cost to reball a PS2?

It’s likely to last many years. So you’re looking at the initial reballing cost (roughly 125$USD) + likely future repairs. This would meet both your goals. Another option is to spend 100$USD or less on a new PS2 to play your old games.

How do I re- solder my PS3?

Reballing your PS3 (re-soldering the chip joints) Look for a reballing service. Ideally, the service will use more durable leaded solder instead of Sony’s lead-free solder. It’s likely to last many years.