The hardware version is located beside or beneath the model number and is labeled version, ver. or V. If there is no version number beside the model number on your Linksys product, the device is version 1.

How do I reset my Cisco Linksys E2500 router?

There are two (2) ways in resetting the Linksys E2500 to factory defaults:

1. Press and hold the Reset button at the bottom of your router for 10 seconds then release.
2. Log in to the router’s web-based setup page then go to Administration > Factory Defaults > Restore Factory Defaults.

Does Linksys E2500 have WPS button?

USB port is used to share disk storage with other users on your network or on the Internet. The USB port is ONLY available to Linksys E2500 v3. Wi-Fi Protected Setup™ (WPS) button is used to automatically configure wireless security for your wireless network(s). To learn more about WPS, click here.

Can I use my E2500 as a repeater?

No offense to you ching_pamz, it seems to be a standard response that these routers can not be used as repeaters or bridges. While this may be true for some or even most models of linksys routers, this E2500 v1 can be used as a bridge. If I was unable to use the router as a bridge, I would be accomplishing the impossible.

Is Linksys E 2500 compatible with Roku?

Networking Extraordinaire : Greetings,The Linksys E2500 router is compatible with the Roku system. Please, let me know when you are ready to continue.

How to connect to Linksys router?

Make sure that the internet port of your Linksys Smart Wi-Fi Router is connected to the modem using an ethernet cable.

What is the default password for a Cisco Linksys 2500 router?

The default IP Address of the Linksys E2500 is 192.168.1.1. The default password is admin and there is no username. IMPORTANT: If the router is configured using the Linksys Connect Software, the new wireless security key will also be the router’s password.