For that reason you must get an accurate voltage reading where the tanning bed will be placed. Buck-boosters lower (buck) or raise (boost) voltage to compensate for these fluctuations. While higher voltage results in more tanning power, you must keep the voltage below 230V for proper operation of the tanning bed.

What is a buck-boost used for?

A buck-boost converter is commonly used to create a constant DC output voltage from a variable DC input voltage source.

How can I tan faster in a tanning bed?

Here are some tips to help you tan faster within a sunbed and make your tan last longer!

1. Exfoliate your Skin prior to Tanning.
2. Keep your Skin Hydrated and Moisturised.
3. Apply a sunbed cream or tanning accelerator prior tanning.
4. Remove any kind of makeup and other cosmetic products.
5. Choose foods that accelerate tanning.

How many amps does a 220v tanning bed pull?

Electrical Requirements: 20 Amp Circuit Breaker. 20 Volt Dedicated Circuit. Important: Voltage must be below 230 VAC or may require a buck booster.

How much power does a tanning bed need?

Residential tanning beds require either a 120 Volt or 240 Volt power source, so be sure to find out which is required for your bed.

What are the advantages of buck converter?

Benefits or advantages of Buck Boost Converters ➨It performs step-up or step-down of voltage using minimum components. ➨It offers lower operating duty cycle. ➨It offers high efficiency across wide input and output voltage ranges. ➨It is less expensive compare to most of the converters.

How do you get the best results from tanning beds?

How to get your best sunbed tan.

1. DO shower, exfoliate and shave.
2. DO apply a non-oil-based light moisturizer right after you shower.
3. DO apply a lip balm with SPF protection.
4. DO use tanning lotions, bronzers and intensifiers formulated exclusively for sunbed tanning.

What vitamins help you tan faster?

The conversion of L-tyrosine into melanin is helped by certain nutrients, notably vitamin C, vitamin B6 and copper. In my experience, taking 2,000mg of vitamin C, 50mg of vitamin B6 and 4mg of copper each day does seem to speed tanning while at the same time reducing the risk of sunburn.

Why do I need a buck-booster for my tanning bed?

For that reason you must get an accurate voltage reading where the tanning bed will be placed. Buck-boosters lower (buck) or raise (boost) voltage to compensate for these fluctuations. While higher voltage results in more tanning power, you must keep the voltage below 230V for proper operation of the tanning bed.

What voltage should I Set my Buck-booster to?

While higher voltage results in more tanning power, you must keep the voltage below 230V for proper operation of the tanning bed. Continued use above 230V may damage the unit and void your warranty. Once you have your voltage reading, please contact your tanning consultant to choose the correct Buck-Booster if required.

What kind of power does a tanning bed use?

The Wolff 24 and the XS Power 24 still run on 120 Volts, but require a 20Amp circuit. The standard for tanning beds is 220 Volts, much like an electric dryer or oven range. It is very important to provide the proper power for your home tanning bed. Impact on electric bills

What are the energy ratings for sunsunco tanning beds?

Sunco Inc. 2013 Energy Ratings Tanning Bed Voltage Cost Per Session Wolff 16 110VAC, 15A 3.8 Cents Wolff 24 110 VAC, 20A 3.7 Cents XS Power 16 110 VAC, 20A 2.5 Cents XS Power 24 110 VAC, 20A 2.8 Cents